Drill Bit Holder 1-13mm Ikea Skadis

1-13mm drill bit holder for an Ikea Skadis pegboard. The holder accommodates a total of 25 drill bits from 1 to 13mm (1/1.5/2/2.5/3/etc.) There are four different versions, two of which are for drill bits with a maximum shank diameter of 10mm, meaning drill bits with a drilling diameter of more than 10mm have a reduced 10mm shank. The other two versions are for drill bit sets where the shank always corresponds to the drilling diameter, i.e., up to 13mm. For each of these two variants, there is an AMS version (the numbers are printed in a different color) and a NonAMS version (the numbers are engraved into the holder). Please, before printing, pay attention to which version is suitable for your drill bit set. Bosch drill bits, for example, usually have a shank reduced to 10mm. On a pegboard, multiple holders can be placed directly next to each other or with a slight gap one above the other. To facilitate removal and optimize space on the pegboard, the slots are arranged at a 45-degree angle. Additionally, on the back of the holder, there is a small compartment to make useful use of the required space. The model can be printed with different materials; minimal support is needed. Especially with the AMS version, attention should be paid to good bed adhesion so that the numbers do not come loose in the first layers; an increase in the bed temperature of 5-10 degrees can be helpful.