Sunflower Petal Spinner (Spinning Flower Fidget)

Added A1M organized profile

UDPATE 3

Shortened stem (IDK where I went wrong)

Disc size increase was accidentally reverted, +1.33% x/y size re-instated

This one was a lot of fun to make & it's my wife's new favorite!

I spent more time, than I care to admit, making sure thbe petals stopped where I wanted them (to make it look like a sunflower as much as possible).

Notes:

ASSEMBLY (Petals are numbered, install them in ascending order 1-6)

Alternate 180° as you place each petal (number facing down) through the top pole of the stem: #1: leaves (3, the 1st one should have the wedge hole alligned with the

#2-4: decreasing size of petals (3 each)

#5: 2 of the smallest petals

#6: top, smallest petal (standalone, does not have a peg)

If done correctly, each tiny peg will sit in a wedge hole of the next petal/piece

Push the disc firmly onto the stem (I recommend using CA glue, once you are satisifed with the result)

The peg is a separate object, with a hole, & a different wall count (to maximize strength)

Different surface layer patterns are used to make things look interesting

Stem prints flat & has 5 walls, to maximize strength While not technically necessary, I like to use supports for the wedge