Modular Storage for All Memoir '44 Figures

There are some notable exceptions however. While this solution can fit one game board, the following needs to be stored separately:

All other game boards (e.g., Winter/Desert board and Breakthrough boards), though you could probably stack another one in if desparate

All the paper Battle Maps

Reference Cards (technically these might be able to fit but I keep them in a separate binder)

Rule books and Campaign Books

What can be stored - all remaining figures, tiles and cards from

Base game

Eastern Front

Pacific Theater

Mediterranean Theater

Terrain Pack

Winter Wars

Operation Overlord

Air Pack

Equipment Pack

Battle Maps

The main 3d printed components are:

One "side" tray for holding the dice (and keeping card holders in place)

Trays (9) to hold the terrain tiles (each tray holds the tiles from one expansion (or half of Terrain Pack))

A couple of specialized trays to hold some of the low-profile figures from Equipment Pack and Battle Maps, as well as the tiles from the Operation Overlord expansion. There is a "misc" tray which is pretty much just there to keep everything in place - room for future expansion (ha ha)!

Some spacers to help hold the game board in place on top of the main box (print 3, the 4th doesn't have much to rest on)

A series of trays, in four different sizes, to hold the rest of the figures and spare components. In my solution, I use:

5 of size A (the largest, good for tanks from one faction)

6 of size B (second largest, good for armies from one faction)

7 of size C (one third the size of A + B)

4 of size D (the smallest, a square equal to half of A)

The way the sizes of these trays work out, there are different combos that can fit into each box:

For main box (with one additional column of tiles and cards), store four of:

A + B

C + C + C

D + D + B

A + a stack of cards (e.g., Breakthrough Deck)

D + D + a stack of cards

For the Equipment Pack box (across the whole width of the box, two layers), e.g., four rows of:

A + B + C

D + D + B + C

C + C + C + C

Printing Instructions

Arrange the trays with the Auto-Arrange button in your slicer and print at a 0.2mm layer height or lower